- You must unzip or decompress the file.
- Put the attached file on a USB stick. (Make sure its in the main page, not in a sub folder within the stick).
- Plug the USB stick into the processor card on the Spa Pack.
- Green and yellow lights will start flashing
- Wait until the yellow light goes out and turns green (it takes about 40 seconds).
- Unplug the USB stick and recycle the power.
- Green and yellow lights will flash again and the Spa will boot-up with the new software.
How to put a file on a usb stick:
There is a video following the steps above available here:
*If they do not start flashing try turning the power to the spa off and then back on with the USB key in place.